Filter
Top Products
Local Terminal Configuration
Using a Local Terminal
21
Firmware Downloads TFTP firmware downloading.
3. Press
S
to save the configuration changes and return to LanProbe’s Main
Menu. If you want to cancel your current changes and return to the
LanProbe’s Main Menu, press
0
.
Modify/View Interface Values
After you access the Modify/View Interface Values menu, you must first select the
port that you want to configure and then configure that port. For example, the
possible options for the port parameter could be the following:
[1] 1.1/Ethernet
[2] 1.2/Serial
Use the following procedure to configure items in the Modify/View Interface
Values menu:
1. Press
3
to access the
Modify/View interface values
menu item. The
Modify/View Interface Values menu is displayed, as shown in Figure 2-8 on
page 21.
Figure 2-8: Modify/View Interface Values Menu
Modify/View Interface Values Menu - Firmware Rev
MAC Address 00 00 C6 XX XX XX
Interface Type Ethernet
1. Port 1.1/Ethernet
2. Port Type Telemetry
3. IP address 0.0.0.0
4. Default gateway IP address 0.0.0.0
5. Subnet mask 255.0.0.0
S. Save changes and exit
0. Cancel changes and exit