Filter
Top Products
Local Terminal Configuration
Using a Local Terminal
20
NOTE
The other Main Menu items are explained in other chapters of this manual. The
TFTP Download new firmware and XMODEM Download new firmware
menu item is described in Chapter 6 “Download New Firmware”. The Warm
start and Exit and Cold start and Exit menu items are explained in Chapter 5
“LanProbe Operation”.
Modify/View Security Values
Use the following procedure to configure items in the Modify/View Security
Values menu:
1. If you want to restrict access to the probe press
2
to access the Modify/View
security values menu item, otherwise skip this section. The Modify/View
Security Values menu is displayed, as shown in Figure 2-7.
Figure 2-7: Modify/View Security Values Menu
2. Select each field requiring configuration (one at a time) by pressing its
corresponding number and then entering the values that are appropriate for
your network. See “Access Security” on page 8. for more information on
security.
Allow Packet Press
1
and enter Yes to allow or enter No to not allow
Capture packet capture.
Allow TFTP Press
2
and enter Yes to allow or enter No to not allow
Modify/View Security Values Menu - Firmware Rev
1. Allow packet capture Yes
2. Allow TFTP firmware downloads Yes
S. Save changes and exit
0. Cancel changes and exit