Filter
Top Products
LanProbe Operation
Restarting the Probe
73
Cycling Power
A power outage or cycling power to LanProbe causes a warm start. LanProbe
does not have a power switch; therefore, cycling the power consists of
disconnecting and reconnecting the power cord.
Selecting the Warm Start Menu Item
Use the following procedure to warm start the probe using LanProbe’s Main
Menu:
1. Connect a local terminal (or a PC emulating a terminal) to LanProbe. Refer
to Chapter 2 “Local Terminal Configuration” for information on connecting
a local terminal.
2. Press the CONFIG button once (on the back of the probe) to place LanProbe
into the configuration mode. Use a narrow, pointed object (like a pen) to
press the recessed CONFIG button. LanProbe then displays its Main Menu
on the terminal. Figure 5-18 shows LanProbe’s Main Menu.
Figure 5-18: LanProbe’s Main Menu
Main Menu - Revision
1. Modify/View configuration values ->
2. Modify/View security values ->
3. Modify/View interface values ->
4. Display interface summary
5. TFTP Download new firmware ->
6. XMODEM Download new firmware ->
7. Warm start and Exit
8. Cold start and Exit