Filter
Top Products
Installation
Connecting the Probe
43
The LanProbe can be configured for Serial Line Internet Protocol (SLIP) link
communications either by using a local terminal through the serial port or by
using a NetMetrix management station over the network.
If you use the network to configure LanProbe, make the network connection (refer
to “Connecting to the Network (In-Band)” on page 37) and then refer to your
NetMetrix documentation to configure the following LanProbe parameters:
Serial Port IP Address
Serial Port Subnet Mask
Serial Port Speed
Hardware Flow Control (if unsure, consult your modem’s documentation)
Modem Init String
If you use an ASCII terminal to configure LanProbe as described in Chapter 2
“Local Terminal Configuration”, attach the terminal and configure the following
LanProbe parameters:
Serial Port IP Address
Serial Port Subnet Mask
Serial Port Speed
Hardware Flow Control (if unsure, ask your local network administrator)
Modem Init String
The Serial Port IP Address must be on the same IP subnet as the management
station’s serial IP address.
Normally, each company has one subnet mask that is used for all machines on
their network. Enter this subnet mask value into the Serial Port Subnet Mask
field. The Serial Subnet Mask used for the probe should match the subnet mask
used for the SLIP port on the management station.
Set the Serial Port Speed to a value that is less than or equal to the maximum
speed at which your modem can operate.
Set the Hardware Flow Control to Off (On is the default), unless you are using
high speed modems (14.4K baud or faster) with advanced features, such as error
correction and data compression. If the Hardware Flow Control is set to On, you
can set it to Off by using LanProbe’s menu or over the network from a NetMetrix
management station (refer to your NetMetrix documentation for details).