Filter
Top Products
0031-731 0031-803
0031-731 Error getting and setting DFS credentials.
Explanation: The PMD called the poe_dce_set function to get and set the current context
for establishing the DFS/DCE credentials when it encountered an error. poe_dce_set
should have issued additional messages describing the errors.
User Response: Contact the system administrator to ensure the DFS/DCE credentials are
properly set up. If the problem persists, Gather information about the problem and follow
local site procedures for reporting hardware and software problems.
0031-732 Error loading POE DFS/DCE routines.
Explanation: The Partition Manager Daemon attempted to load poe_dce_set.o, the
loadable object for the DFS/DCE routines it uses for setting up the user's credentials.
Possibly DFS/DCE was not installed or is inoperable, or the required installation steps for
running POE with DFS were not done.
User Response: Contact the system administrator to ensure that DFS/DCE is properly
installed and that the necessary POE installation steps were completed. If the problem
persists, gather information about the problem and follow local site procedures for reporting
hardware and software problems.
0031-733 The initialization of the remote debug engine failed.
Explanation: The Partition Manager Daemon detected an error while starting the remote
debug engine. The debugger is terminated.
User Response: The remote debug engine portion of pdbx and pedb depend on the
bos.adt.debug fileset. Contact your system adminstrator to make sure that the fileset
bos.adt.debug is properly installed on the nodes where the job runs.
0031-734 POE DFS master file was not found. DFS credentials cannot be established.
Explanation: POE did not find the POE DFS credentials master file,
/tmp/poedce_master,<
uid>
. DFS user authentication was selected (by specifying MP_AUTH
= DFS), but most likely the poeauth command was not run to set up the DFS/DCE
credentials. As a result, DFS authentication cannot be established and the job is terminated.
User Response: Make sure a valid set of DFS/DCE credentials were successfully copied
using a dce_login and running the poeauth command, then run the POE job again.
0031-800 -procs
string
ignored in remote child
Explanation: -procs interpreted only in parent code.
User Response: No response needed.
0031-801 -hostfile
string
ignored in remote child
Explanation: -hostfile interpreted only in parent code.
User Response: No response needed.
0031-802 -newjob
string
ignored in remote child
Explanation: -newjob interpreted only in parent code.
User Response: No response needed.
0031-803 -pmdlog
string
ignored in remote child
Explanation: -pmdlog interpreted only in parent code.
User Response: No response needed.
100 IBM PE for AIX V2R4.0: Messages