Filter
Top Products
0031-135 0031-142
0031-135 Invalid labelio option, should be YES or NO
Explanation: A labelio other than YES or NO was entered.
User Response: Re-specify labelio with either YES or NO.
0031-136 Invalid MP_NOARGLIST option, should be YES or NO
Explanation: The Partition Manager terminates.
User Response: Enter YES or NO for MP_NOARGLIST.
| 0031-137 poe: Internal Error: Could not broadcast ACK for
string
data
| Explanation: An error occurred when POE was trying to acknowledge receipt of connect or
| finalize data from all nodes. Either one of the remote nodes is no longer accessible or a
| system error has occurred.
| User Response: Verify that the remote nodes in the partition can be contacted by other
| means. If the problem persists, gather information about the problem and follow local site
| procedures for reporting hardware and software problems.
0031-138 The following nodes may be causing connect failures during message
passing initialization:
Explanation: The home node has gathered connect data from each of the remote nodes
and has determined that one or more nodes have been reported most as not connectable to
during message passing initialization. A list of those nodes proceeds this message.
User Response: For jobs using the SP, contact System Administrator to determine if that
node is up on the switch. For non-SP jobs, verify that the node can be contacted by other
means. Also, refer to the node-specific error message related to mpci_connect for more
information on what could be causing the problem (e.g. unauthorized user). If problem
persists, gather information about the problem and follow local site procedures for reporting
hardware and software problems.
0031-139 Could not open socket for debugger.
Explanation: The call to socket() failed when attempting to open a socket for the parallel
debugger.
User Response: None.
0031-140 Could not bind local debug socket address.
Explanation: The call to bind() failed when attempting to bind the local address for the
debug socket.
User Response: None.
0031-141 Could not accept debugger socket connection.
Explanation: The call to accept() failed when attempting to make a socket connection with
the debugger.
User Response: None.
0031-142 Could not write to debug socket.
Explanation: The call to write() failed when attempting to write to the debug socket.
User Response: None.
62 IBM PE for AIX V2R4.0: Messages