Filter
Top Products
0030-0121 0030-0129
| 0030-0121 The MPI application has not been run in debug mode; therefore, there will
| be no data on blocking calls and no timestamp information.
| Explanation: Some MPI debugging data is only collected when MPI is run in DEBUG
| mode.
| User Response: See the documentation concerning the setting of the MPI_EUIDEVELOP
| environment variable.
| 0030-0122 Could not create a new request record.
| Explanation: This is an internal debugger error most likely caused by either a memory
| allocation failure or the fact that the record already exists.
| User Response: Try canceling the message queue debugging windows and starting over
| again. If the error persists, try to make sure there is sufficient memory available.
| 0030-0123 Could not retrieve the needed request record.
| Explanation: This is an internal debugger error which indicates that a message queue
| debugging request record that should exist could not be found.
| User Response: Cancel the message queue debugging windows and start over.
| 0030-0124 Task
task
is not in pedb DEBUG mode.
| Explanation: Informational message.
| User Response: None.
| 0030-0125 Task
task
is not in the current context for view 0.
| Explanation: Informational message.
| User Response: None.
| 0030-0126 MPI has not been initialized for task
task
.
| Explanation: Informational message.
| User Response: None.
| 0030-0127 MPI has been finalized for task
task
.
| Explanation: Informational message.
| User Response: None.
| 0030-0128 Select a new filter (or filters), then press Apply or OK.
| Explanation: Informational message displayed in the Select Filters window.
| User Response: None.
| 0030-0129 Select a message to get message details or group information.
| Explanation: Informational message displayed in the task message queue window.
| User Response: None.
Chapter 3. pedb Messages 33