Filter
Top Products
0030-2241 0030-2257
0030-2241 Task
number
loaded with
string
string
.
Explanation: Describes what executable and arguments were loaded for a particular task.
User Response: None. This is an informational message.
0030-2242 Unable to send command to task '
number
'.
Explanation: An error occurred in sending an pedb command to the indicated task.
Probably the remote node is no longer accessible.
User Response: Verify that the remote node in the partition can be contacted by other
means. If problem persists, gather information about the problem and follow local site
procedures for reporting hardware and software problems.
0030-2243 No more new views are available.
Explanation: During an pedb session there is a limit to how many views can be created.
Also, once a view has been closed it cannot be reopened.
User Response: You can use the views that are left to continue debugging.
0030-2244 ALL tasks have exited. Quit and restart pedb if you wish to continue.
Explanation: All the tasks of the partition have exited.
User Response: Quit pedb.
0030-2245 Internal pedb error at line
number
in file '
string
'.
string
Explanation: This is a generic message to mark a situation that should not have occurred.
User Response: Retry the operation or restart pedb. If you continue to get this error
message, gather information about the problem and follow local site procedures for reporting
hardware and software problems.
0030-2246 Cannot perform this function in a context unless all the tasks are in
DEBUGGED state.
Explanation: This is a generic message to mark a situation in which a function could not
be performed because not all tasks in the context were in DEBUGGED state.
User Response: Switch to a context where all tasks are in DEBUGGED state.
0030-2250 Task
number
has been sent halt execution.
Explanation: Halt execution for this task has been selected. This task was running and a
request to the remote debugger has been made to stop the task.
User Response: If the remote debugger is able to regain control over the task, the user
should be able to continue debugging this task with pedb.
0030-2257 Tasks:
string
in group:
string
have been sent halt execution.
Explanation: Halt execution for this group has been selected. For each task in the group
that was running, a request to the remote debugger has been made to stop the task.
User Response: You will be able to continue debugging on the tasks that the remote
debugger is able to regain control over.
38 IBM PE for AIX V2R4.0: Messages