Filter
Top Products
0029-9041 0029-9048
0029-9041 Cannot locate attach configuration file "
string
".
Explanation: pdbx was unable to locate the attach configuration file.
User Response:
1. Make sure that the correct POE process id was used when invoking the debugger.
2. Check the /tmp directory for the existence of a configuration file containing the POE
process id. (For example, check for /tmp/.ppe.34192.attach.cfg).
0029-9042 No tasks listed in attach configuration file.
Explanation: The attach configuration file created when the original POE job was started
contained a zero in the first field indicating that POE is between job steps.
User Response: Wait for the next job step to start which will take a few seconds. Then you
can re-enter pedb in attach mode, if you wish.
0029-9043 The command "
string
" is not valid when debugging in attach mode.
Explanation: The command is not valid when debugging in attach mode.
User Response: Use a different command.
0029-9044 Could not write to poe debug socket.
Explanation: pdbx was unable to write to the POE debug socket.
User Response: The debugger was unable to communicate to POE that the debugger is
detaching. Please note that the debugger will most likely not be able to re-attach to this
POE job.
0029-9045 The "detach" command can only be used when running in attach mode.
Explanation: The detach command is only valid if the debugger has been attached to a set
of tasks.
User Response: Use quit to exit the debugger if running in normal mode.
0029-9046 The correct syntax is: '
string
'.
Explanation: You issued incorrect syntax, and the correct syntax is displayed as part of
this message.
User Response: Retype the command using the syntax displayed.
0029-9047 An instance of pdbx has already been attached to this POE job.
Explanation: Only one instance of the debugger may be attached to a given POE job at a
time. The existence of the /tmp/.pdbx.<
"poe-pid">
.host.list file indicates that a debugger
has already attached to this POE job.
User Response: If pdbx isn't currently attached to the POE job in question, remove the
corresponding /tmp/.pdbx.<
"poe-pid">
.host.list file in /tmp, and try again.
0029-9048 The following flag(s) are not valid when starting the debugger in attach
mode - Please check for valid flags and retry.
Explanation: The user attempted to start pedb in attach mode with a command line flag(s)
that is not valid. The error message is given and the debugger exits.
User Response: The user should check for valid command line flags and try again.
22 IBM PE for AIX V2R4.0: Messages