Filter
Top Products
SmartConnect User’s Guide
126
Chapter 10: System Settings BMD00082, February 2009
Management Network Settings
Use this window to add a defined network through which switch access is allowed through
Telnet, SNMP, SSH, or the SmartConnect browser-based interface (BBI). A range of IP
addresses is produced when used with a network mask address. Specify an IP address and
mask address in dotted-decimal notation.
Note: If you configure the management network without including the switch interfaces, it will
cause the Firewall Load Balancing health checks to fail and will create a “Network Down”
state on the network.
Bootstrap Protocol Settings
Use this window to configure BOOTP settings.
Table 10-11 Management Network Configuration Fields
Field Description
Index Displays the numeric ID of each management network entry.
Management Network
Address
Configures the IP address of the management network.
Management Network Sub-
net Mask
Configures the subnet mask of the management network.
Table 10-12 BOOTP Configuration Fields
Field Description
BOOTP State Globally enable or disable BOOTP relay on the switch.
BOOTP Server IP Address Sets the IP address of the BOOTP server.
Secondary BOOTP Server IP
Address
Sets the IP address of the second BOOTP server (optional).