Filter
Top Products
BMD00082, February 2009 133
CHAPTER 11
Boot Management
Use the Boot Management window to manage SmartConnect software. The Boot Management
window allows you to perform the following tasks:
General Boot Settings:
Select a software image to be used when the SmartConnect is next reset.
Select a configuration block to be used when the SmartConnect is next reset.
Download or upload a new software image to the SmartConnect via FTP/TFTP/
HTTP.
Boot Schedule: Set a time when the switch will next reset.
General Boot Settings
Perform the following steps to load a software image to the SmartConnect:
1. In the Image to transfer drop-down list, select the software image you wish to replace.
2. In the Update Image/Cfg section, perform the following steps:
Select the method to use for transfer from the drop-down list.
Enter the appropriate information to use for the file transfer.
3. Click Get Image.
Once the image has loaded, the page refreshes to show the new software. To activate the new
software, select the appropriate Image to boot, and click Reboot.