Filter
Top Products
SmartConnect User’s Guide
BMD00082, February 2009 Chapter 6: Configuring Switch Access
79
Configuring SSH/SCP Features
SSH and SCP are disabled by default. Before you can use SSH commands, you must turn on
SSH/SCP. Begin a Telnet session from the management system and enter the following CLI
command:
Enabling or Disabling SCP Apply and Save
Enter the following commands from the CLI to enable the SCP putcfg_apply and
putcfg_apply_save commands:
>> # /cfg/sys/sshd/on (Turn SSH on)
Current status: OFF
New status: ON
>> # /cfg/sys/sshd/ena (Enable SCP apply and save)
SSHD# apply (Apply the changes to start generating RSA
host and server keys)
RSA host key generation starts
.............................................................
......................................................
RSA host key generation completes (lasts 212549 ms)
RSA host key is being saved to Flash ROM, please don't reboot
the box immediately.
RSA server key generation starts
............................................................
RSA server key generation completes (lasts 75503 ms)
RSA server key is being saved to Flash ROM, please don't reboot
the box immediately.
------------------------------------------------------------------
Apply complete; don't forget to "save" updated configuration.
>> #
/cfg/sys/sshd/dis (Disable SSH/SCP apply and save)