Filter
Top Products
SmartConnect User’s Guide
76
Chapter 6: Configuring Switch Access BMD00082, February 2009
Configuring End-User Access Control
1. On the BBI, choose System Settings > Local User Administration.
Figure 6-B Local User Administration Window
2. In the User Configuration section, enter a Username and Password for the account.
3. Select the User Type.
By default, the end user is assigned to the user access level (also known as Class of Service, or
CoS). CoS for all user accounts have global access to all resources except for User CoS, which
has access only to view resources that the user owns. Refer to Table 6-2 on page 72.
4. Select enable to allow the new user to access the switch.
5. Click Apply to make your changes active, and Save to retain changes beyond reboot.
Logging in to an End-User Account
Once an end-user account is configured and enabled, the user can login using the
username/password combination. The level of access is determined by the Class of Service
configured for the end-user account.