Filter
Top Products
General Information
SECTION 1
1-24
6400 Hand-Held Computer User’s Guide
Flash
Flash memory is available in 2 or 4 Megabytes. Flash
stores the BIOS and DOS. Software stored in flash is copied
into DRAM for execution. Your application may also store
information in flash memory. Flash memory retains data
even if all power sources are depleted.
Diagnostic EEPROM
The hand-held computer collects and stores diagnostics.
They can provide useful information to an Intermec Cus-
tomer Support Specialist, should your computer fail to oper-
ate. You will be instructed by Intermec service personnel to
complete the necessary steps while they are troubleshooting
your system with you.
Resetting
In the rare event that your hand-held computer fails to re-
spond to your input, it may be necessary to “reset.” A
“hard” reset of your computer is done by holding down the
Blue, Yellow and both ENT (Enter) keys all at the same
time, until your computer starts beeping. This usually
takes about 1--2 seconds. This method is equivalent to pow-
ering off and on with a PC. Resetting (also called rebooting)
can up to 45 seconds.
Depending on the type of overlay your computer i s pro-
grammed for, usually a “soft” r eset is done by pressing Ctrl,
Alt, and Delete.