Filter
Top Products
Section 3 PREPARATIONS
3-3
8
Insert the appropriate paper size label into the front of the
drawer to indicate the size of paper that is loaded into that
drawer.
NOTE
If you will not be using the copier for a prolonged period of time,
remove all paper from the drawer(s) and seal in its original packaging
in order to protect it against moisture.
(3) Setting paper on the multi-bypass tray
Up to 150 sheets of standard paper (75 g/m
2
– 90 g/m
2
) can be set on
the multi-bypass tray. Paper sizes between 5 1/2" x 8 1/2",
8 1/2" x 5 1/2", 8 1/2" x 11, 11" x 8 1/2", 8 1/2" x 14, 11" x 17" and
12" x 18" [B6R, A5R, B5R, B5, A4R, A4, B4, A3, A3 wide (305 mm x
457 mm) and Folio] can be used. When copying onto special paper,
be sure to use the multi-bypass tray.
NOTE
• The following types of special paper and the number of sheets that
can be set on the multi-bypass tray at one time are as follows:
OHP transparencies: 25 sheets (BE SURE to use only 11" x 8 1/2"
[A4] size OHP transparencies and ALWAYS fan through
transparencies before setting them on the multi-bypass tray.)
Thick paper (91 g/m
2
– 220 g/m
2
): 50 sheets
• The acceptable paper weight for thick paper actually differs
depending upon the size of the paper:
Under 11" x 8 1/2" [A4]: 91g/m
2
– 220 g/m
2
Over 11" x 8 1/2" [A4]: 91g/m
2
– 135 g/m
2
IMPORTANT!
• BE SURE to use paper that is specified for color copy use in order
to make clear color copies.
• DO NOT use paper such as that designated for inkjet printers or any
paper treated with special coating.
• When setting special paper such as OHP transparencies and thick
paper on the multi-bypass tray, be sure to specify the type of paper
under “● When setting OHP transparencies or thick paper on the
multi-bypass tray” on page 3-5.
1
Open the multi-bypass tray.
NOTE
When copying onto 8 1/2" x 11" [A4R] size paper or larger, be sure to
pull out the multi-bypass extension.
2
Adjust the insert guides to fit the width of the paper that is to
be set on the multi-bypass tray.