Kyocera KM-C830D Printer User Manual


 
Section 7 COPIER MANAGEMENT
7-21
&Custom erase size
1
Press the O cursor or the P cursor key to select the length
of the original to be used in the custom erase mode.
(The length can be set to any 5/16" increment between
3 11/16" and 8 7/16" [any 8 mm increment between 94 mm and
214 mm.])
Inch specifications
Metric specifications
2
Press the N cursor key to change to the width size setting.
3
Press the O cursor or the P cursor key to select the paper
width. (The length can be set to any 1/8" increment between
2 3/8" and 11 5/8" [any 4 mm increment between 60 mm and
296 mm.])
Inch specifications
Metric specifications
4
Press the Enter key.
*Insert tray
1
Use the M cursor or the N cursor key to select the drawer
that contains the paper which will be fed in the insert sheet
modes.
* The 1 paper [SOURCE 1] drawer is not available in
duplex copiers.
Inch specifications
Metric specifications
2
Press the Enter key.
(Sort mode ON/OFF (Output form)
1
Use the M cursor or the N cursor key to select either
z On or x Off.
Inch specifications
Metric specifications
2
Press the Enter key.