Filter
Top Products
7: Setup Mode: Channel Configuration
WiBox® 2100E Device Server User Guide 58
Table 7-8. Modem Mode Commands
Modem Mode Command Function
ATDTx.x.x.x,pppp or
ATDTx.x.x.x/pppp or
ATDTx.x.x.x:pppp
Makes a connection to an IP address (x.x.x.x) and a remote port number
(pppp).
ATDTx.x.x.x
Makes a connection to an IP address (x.x.x.x) and the remote port
number defined within the unit.
ATD0.0.0.0
Forces the unit into Monitor Mode if a remote IP address and port number
are defined within the unit.
ATD or ATDT
Forces the unit into Monitor Mode if a remote IP address and port number
are not defined within the unit.
ATDx.x.x.x
Makes a connection to an IP address (x.x.x.x) and the remote port
number defined within the unit.
ATH
Hangs up the connection (Entered as +++ATH).
ATS0=n
Enables or disables connections from the network going to the serial port.
n=0 disables the ability to make a connection from the network to the
serial port.
n=1-9 enables the ability to make a connection from the network to the
serial port.
n>1-9 is invalid.
ATEn
Enables or disables character echo and responses.
n=0 disables character echo and responses.
n=1 enables character echo and responses.
ATVn
Enables numeric response or full verbose.
n=0 enables numeric response.
n=1 enables full verbose.
Note: The unit recognizes these AT commands as single commands such as ATE0 or
ATV1; it does not recognize compound commands such as ATE0V.
Send the Escape Sequence (+++) in Modem Mode
Send ‘+++’ in Modem Mode (Y) ? _
Disable or enable the WiBox 2100E’s ability to send the escape sequence. The default setting is
Y (Yes) (send the escape sequence).
Show IP addr after 'RING'
Show IP addr after ‘RING’ <Y> ?
Disable or enable the WiBox 2100E's ability to show the IP address after RING in Modem Mode.
The default is Y (Yes), to show the IP address.