Filter
Top Products
10: Updating Firmware
WiBox® 2100E Device Server User Guide 79
Figure 10-1. TFTP Window
After the firmware has been loaded and stored, which takes approximately 8 seconds, the unit
performs a power reset.
Using TFTP: Command Line Interface
To download new firmware from a computer:
1.
Enter the following from a TFTP command line interface:
tftp –i <ip address> put <local filename> <destination file name>
The following examples demonstrate the TFTP command sequence to download the .rom file and
the .cob file:
tftp –i 192.168.1.111 put wbxg_6102.rom W7
tftp –i 192.168.1.111 put wbx_webm_1403.cob WEB1
2. In the Remote file name field, enter the current internal operational code or WEB1 for the
internal Web interface.
Network Upgrade
Use the command: tftp –i <ip address> put <wbx rom filename> W7 or the
DeviceInstaller upgrade feature. DI 4.0.0.4 and later support the W7 destination file.
Recovering the Firmware Using the Serial Port and
DeviceInstaller
If for some reason the firmware is damaged, you can recover the firmware file by using
DeviceInstaller to download the *.ROM file over the serial port.