Filter
Top Products
Network/Ports
37
Using MFP menus
Protocol Specifies the parallel interface
protocol.
Standard May resolve some parallel interface
problems.
Fastbytes* Provides compatibility with most
existing parallel interface
implementations (recommended
setting).
Honor Init Determines whether the MFP
honors hardware initialization
requests from the computer. The
computer requests initialization by
activating the INIT signal on the
parallel interface. Many personal
computers activate the INIT signal
each time the computer is turned on
and off.
Off* The MFP does not honor hardware
initialization requests from the
computer.
On The MFP honors hardware
initialization requests from the
computer.
Parallel Mode 2 Determines whether the parallel
port data is sampled on the leading
or trailing edge of strobe.
This menu item only appears when
the associated parallel port
supports this feature.
On* Samples parallel port data on the
leading edge of strobe.
Off Samples parallel port data on the
trailing edge of strobe.
Mac Binary PS Configures the MFP to process
Macintosh binary PostScript print
jobs.
On The MFP processes raw binary
PostScript print jobs from computers
using the Macintosh operating system.
Note: This setting often causes
Windows print jobs to fail.
Off The MFP filters PostScript print jobs
using the standard protocol.
Auto* The MFP processes print jobs from
computers using either Windows or
Macintosh operating systems.
ENA Address Sets the parallel port ENA Address. 4 field IP address
(0.0.0.0*)
Shown only if an ENA is attached
through the parallel port.
ENA Netmask Sets the parallel port ENA Netmask.
ENA Gateway Sets the parallel port ENA Gateway.
Menu item Purpose Values and descriptions