Filter
Top Products
98
Attendance messages
Clean scanner glass During a scanner calibration, the
firmware detects that the scanner
ADF or flatbed glass may be dirty.
Touch Cancel Job if a scan job is processing
when the attendance message appears. This
cancels the job and clears the message.
Touch Scan from Automatic Document Feeder
if the page jam recovery is active. Scanning
resumes from the ADF immediately after the
last successfully scanned page.
Touch Scan from flatbed if page jam recovery is
active. Scanning resumes from the flatbed
immediately after the last successfully scanned
page.
Touch Finish job without further scanning if
page jam recovery is active. The job ends at the
last successfully scanned page, but the job is
not canceled. Successfully scanned pages go
to their destination: copy, fax, e-mail, or FTP.
Touch Restart job if job recovery is active and
the job is restartable. The message clears. A
new scan job containing the same parameters
as the previous job starts.
Close door or insert
cartridge
The MFP detects that the upper front
door is open or a print cartridge is
missing.
• Close the upper front door.
• Install the print cartridge.
Fax Memory Full There is no memory to complete a fax
job. Any attempted fax jobs are
canceled.
Touch Continue to clear the message.
If restarting job,
replace originals that
have not begun to exit
the scanner.
Page level recovery is active, and a
page has scanned completely, but it
has not fully exited the ADF.
Touch Cancel Job if a scan job is processing
when the attendance message appears. This
cancels the job and clears the message.
Touch Scan from Automatic Document Feeder
if the page jam recovery is active. Scanning
resumes from the ADF immediately after the
last successfully scanned page.
Touch Scan from flatbed if page jam recovery is
active. Scanning resumes from the flatbed
immediately after the last successfully scanned
page.
Touch Finish job without further scanning if
page jam recovery is active. The job ends at the
last successfully scanned page, but the job is
not canceled. Successfully scanned pages go
to their destination: copy, fax, e-mail, or FTP.
Touch Restart job if job recovery is active and
the job is restartable. The message clears. A
new scan job containing the same parameters
as the previous job starts.
Insert tray [x] Occurs when the MFP detects a
missing tray. x can be 1, 2, 3, 4, or 5.
Insert the specified tray to clear the message.
Touch Cancel Job to cancel the current job if
needed.
Install duplex The MFP detects that the duplex unit
is missing. This message occurs
when pages are formatted when the
duplex unit is present, but before the
pages are printed. Between the
formatting and printing time, the
duplex unit is removed from the MFP.
• Turn the MFP off, unplug the power cord from
the wall outlet, install the duplex unit, connect
the power cord to a properly grounded outlet,
and then restart the MFP.
•Touch Cancel Job to cancel the current job.
Message Meaning Action