Filter
Top Products
69
Job
Accounting
To store statistical information about
your most recent print jobs on the hard
disk. The statistics include whether the
job printed with or without errors, the
print time, the job size (in bytes), the
requested paper size and paper type,
the total number of printed pages, and
the number of copies requested.
Note: Job Accounting is only displayed
when a hard disk is installed, is neither
defective nor Read/Write or Write
protected, and Job Buffer Size is not
set to 100%.
Off* Printer does not store job statistics on
disk.
On Printer stores job statistics for the most
recent print jobs.
Page Protect
To successfully print a page that may
otherwise generate Complex Page
errors.
If, after selecting On, you still cannot
print the page, you may also have to
reduce the size and number of fonts on
the page, or increase the installed
printer memory.
For most print jobs, you do not need to
select On. When On is selected,
printing may be slower.
Off* Prints a partial page of data if memory
is insufficient to process the entire
page.
On Ensures that an entire page is
processed before it prints.
Power Saver
To specify the amount of time (in
minutes) the printer waits after a job is
printed before it goes into a reduced
power state.
Disabled This value does not appear unless
Energy Conserve is set to Off. See
Disabling Power Saver for more
information.
1...240 Specifies the amount of time after a
print job before the printer goes into
Power Saver mode. (Your printer may
not support the entire range of values.)
The factory default Power Saver
setting depends on your printer model.
Print the menu settings page to
determine the current Power Saver
setting. When the printer is in Power
Saver mode, it is still ready to receive
print jobs.
Select 1 to put the printer in Power
Saver mode one minute after it finishes
a print job. This uses much less
energy, but requires more warm-up
time for the printer. Select 1 if your
printer shares an electrical circuit with
room lighting and you notice lights
flickering.
Select a high value if your printer is in
constant use. Under most
circumstances, this keeps the printer
ready to print with minimum warm-up
time. Select a value between 1 and
240 minutes if you want a balance
between energy consumption and a
shorter warm-up period.
Menu Item Purpose Values