Filter
Top Products
82
Prog System Code
The printer is programming new
system code.
Wait for the message to clear and the
printer to reset.
Warning: Do not turn the printer off while
this message is displayed.
Program Flash
The printer is storing resources, such
as fonts or macros, in flash memory.
Wait for the message to clear.
Warning: Do not turn the printer off while
this message is displayed.
Programming Disk
The printer is storing resources, such
as fonts or macros, on the hard disk.
Wait for the message to clear.
Warning: Do not turn the printer off while
this message is displayed.
Programming Error
P<x>
An error occurred while the printer was
programming code into memory.
Correct the problem specified on the
second line of the display:
• P105—A network file was used to
program a non-network printer, or a non-
network file was used to program a
network printer.
• P109—An update file was used to
program the printer, but the information
did not fit within the space allocated in
the Master Boot Record.
• P112—An upddle.fls file was used to
update the DLE code on a printer with a
firmware card installed, but the DLE was
not found on the firmware card.
• P200—No firmware card is installed.
Queuing and Deleting
Jobs
The printer is deleting one or more
held jobs and sending one or more
jobs to print.
Wait for the message to clear.
See also: Printing and deleting held jobs
Queuing Jobs
The printer is sending one or more
held jobs to print.
Wait for the message to clear.
See also: Holding a job in the printer
Ready
The printer is ready to receive and
process print jobs.
Send a job to print.
Ready Hex
The printer is in Hex Trace mode and
is ready to receive and process print
jobs.
• Send a job to print. All data sent to the
printer is printed in hexadecimal and
character representation. Control strings
are printed, not executed.
• Turn the printer off and then on to exit
Hex Trace mode and return to Ready
status.
Reattach <device>
The specified device is either not fully
connected to the printer or is
experiencing a hardware failure.
• Reestablish communication by removing
the specified device and reattaching it to
the printer.
•Press Go to clear the message and
continue printing without using the
device.
• In the case of a hardware failure, turn
the printer off and back on. If the error
recurs, turn the printer off, remove the
specified device, and call for service.
See also: Calling for service
Message What this message means What you can do