Filter
Top Products
89
58 Too Many Disks
Installed
Too many hard disks are installed on
the printer. The printer only supports
one hard disk at a time.
Turn off and unplug the printer. Remove the
excess hard disks from the printer. Plug in
the printer and turn it on.
See also: Removing memory and option
cards
58 Too Many Flash
Options
Too many flash memory options are
installed on the printer.
Turn off and unplug the printer. Remove the
excess flash memory. Plug in the printer
and turn it on.
See also: Removing memory and option
cards
59 Incompatible
<device>
You have installed an incompatible
device.
Remove the device and press Go to clear
the message.
61 Defective Disk
The printer detects a defective hard
disk.
•Press Go to clear the message and
continue printing.
• Install a different hard disk before you
perform any operations that require one.
See also: Setup Guide
62 Disk Full
There is not enough memory on the
hard disk to store the data sent to the
printer.
•Press Go to clear the message and
continue processing. Any information not
previously stored on the hard disk is
deleted.
• Delete fonts, macros, and other data
stored on the hard disk.
63 Unformatted Disk
The printer detects an unformatted
hard disk.
•Press Go to clear the message and
continue printing.
• Format the disk before performing any
disk operations. To format the disk,
select Format Disk from the Utilities
Menu.
• If the error message remains, the hard
disk may be defective and require
replacing. Install a new hard disk and
format it.
See also: Format Disk
64 Disk Not Supported
The printer detects that an
incompatible hard disk is installed.
Turn the printer off and remove the disk.
See also: Removing memory and option
cards
64 Unsupported Disk
Format
The printer detects an unsupported
disk format.
•Press Go to clear the message.
• Format the disk.
Note: Disk operations are not allowed
until the disk is formatted.
80 Fuser Maintenance
The counter that tracks wear on the
fuser has reached its limit.
•Press Go to continue printing.
• If print quality is unacceptable, replace
the fuser.
81 Engine Code CRC
Failure
Microcode in the engine flash code
module has failed a system check.
•Press Go to clear the message.
• Discard the code. Retransmit the
microcode data from the host computer.
Message What this message means What you can do