Filter
Top Products
Di152f/Di183f vii
To set the “INITIAL MODE” function .............................................9-10
9.2 Setting Up the Paper Sources
(“PAPER SOURCE SETUP” Menu)............................................9-11
To select the “PAPER SOURCE SETUP” menu...........................9-12
To specify the automatic paper size detection units
(“INCH/METRIC” function) ............................................................9-13
To specify the size of paper loaded into the 1st Tray
(“TRAY1 PAPER” function)...........................................................9-14
To set the “AUTO SELECT” function ............................................9-16
9.3 Specifying User-Managed Service Tasks
(“USER MANAGEMENT” Menu).................................................9-17
To perform the “DRUM DEHUMIDIFY” function ...........................9-17
To perform the “TONER REPLENISHER” function.......................9-18
9.4 Specifying Administrative Settings
(“ADMIN. MANAGEMENT” Menu)..............................................9-19
To select the “ADMIN. MANAGEMENT” menu.............................9-20
To set the “AUTO SHUT OFF” function ........................................9-21
To turn on/off user (section) management....................................9-22
To register user (section) access numbers...................................9-23
To change/delete user (section) access numbers ........................9-24
To display/clear the total count for a specific account...................9-26
To print the total counts for all accounts (sections).......................9-28
To clear the total counts for all accounts.......................................9-29
To set the “REMOTE MONITOR” function....................................9-30
9.5 Specifying Copy Settings
(“COPY SETTING 1” & “COPY SETTING 2” Menus)................9-31
To select the “COPY SETTING 1” menu ......................................9-32
To set the “PAPER PRIORITY” function.......................................9-33
To set the “DENSITY PRIORITY” function....................................9-34
To set the “AUTO” density level
(“DENSITY LEVEL(A)” function) ...................................................9-34
To set the manual density level
(“DENSITY LEVEL(M)” function)...................................................9-35
To set the “BINDING POS.” function.............................................9-35
To specify the binding width (“MARGIN SETTING” function) .......9-36
To specify the erased width (“ERASE SETTING” function) ..........9-36
To select the “COPY SETTING 2” menu ......................................9-37
To set the “MIXED ORIGINAL” function........................................9-38
To set the “COPY PRIORITY” function.........................................9-38
To specify the default finishing mode
(“OUTPUT PRIORITY” function)...................................................9-39
To set the “4IN1 COPY ORDER” function ....................................9-39
To set the “CRISSCROSS MODE” function..................................9-40