Filter
Top Products
9
Utility Mode – Copy Functions
9-14 Di152f/Di183f
To specify the size of paper loaded into the 1st Tray (“TRAY1
PAPER” function)
1
Select the “PAPER SOURCE
SETUP” menu.
❍ Refer to “To select the “PAPER
SOURCE SETUP” menu” on
page 9-12.
2
Press the [2] key from the 10-Key
Pad to select “TRAY1 PAPER”.
3
Using the and keys, select
“PLAIN”, “OHP” or “CARD”, and
then press the [Yes] key.
4
Using the and keys, select
either “AUTO” or “SIZE INPUT”, and
then press the [Yes] key.
❍ If “AUTO” was selected, the
“PAPER SOURCE SETUP”
menu appears again.
❍ If “SIZE INPUT” was selected, a screen appears, allowing you to
specify the paper size.
5
Using the 10-Key Pad, enter the
paper length (mm), and then press
the [Yes] key.
❍ The paper length can be set
between 5-1/2 inch (140 mm)
and 17 inch (432 mm).
However, when the length is set between 16-9/16 inch (421 mm)
and 17 inch (432 mm), the maximum width that can be set is
11 inch (279 mm).
❍ If you wish to correct the setting, press the [No] key, and then enter
the new number.