Filter
Top Products
Error Messages
12
Di152f/Di183f 12-19
SET ORIGINAL TO ADF A document was not loaded
into the Automatic Document
Feeder before beginning a
copy function (such as, “2in1”
copying or “Mixed Orig.”
copying) that uses the
Automatic Document Feeder.
Otherwise, the Automatic
Document Feeder is lifted up.
Load a document into the
Automatic Document Feeder.
Securely close the Automatic
Document Feeder.
REMOVE PAPER When interrupting a copy job
to perform a different copy
operation other than the
“Book Separation” function,
the document for the
interrupted copy job was left
in the Automatic Document
Feeder.
Remove the document from
the Automatic Document
Feeder.
TEXT
×
1.0 1
ä
[A]
ü
#XXX:EMPTY
(While specifying copy
settings)
The selected paper tray has
run out of paper.
“#” indicates the paper tray,
and “XXX” indicates the
paper size.
Either load paper of the
specified size into the
specified paper tray, or press
the [Paper] key and select a
different paper size.
NO SUITABLE PAPER • While copying, the size of
the paper in the selected
paper tray has changed.
• While copying documents
with mixed sizes using the
“Auto Paper” function,
paper of a suitable size
could not be found.
“#” indicates the paper
tray, and “XXX” indicates
the paper size.
Either load paper of the
specified size, or press the
[Paper] key and select a
different paper size.
(Flashing alternately)
LOAD PAPER (#XXX)
APS SIZE ERROR While copying using the
“Auto Paper” function, paper
of a suitable size could not be
found.
Either load paper of a
suitable size, or press the
[Paper] key and select a
different paper size.
AMS SIZE ERROR While copying using the
“Auto Size” function, the
combination of the document
and paper sizes caused the
zoom ratio to exceed the
range between
×
0.5 and
×
2.0.
Either load paper of a
suitable size, or use the
and keys to specify the
zoom ratio.
PAPER SIZE ERROR The paper loaded in the
paper tray caused a size
error.
“#” indicates the paper tray,
and “XXX” indicates the
paper size.
Pull open the paper tray with
the size error, and then close
it again.
Check if a custom paper size
has been entered, and
correct the paper size using
the appropriate Utility mode
function.
(Flashing alternately)
RESET PAPER (#XXX)
Message Cause Remedy