Filter
Top Products
Chapter 3 Replication Management
93
3
3
3
.
.
.
3
3
3
.
.
.
1
1
1
4
4
4
S
S
S
a
a
a
v
v
v
e
e
e
P
P
P
a
a
a
i
i
i
r
r
r
S
S
S
e
e
e
t
t
t
t
t
t
i
i
i
n
n
n
g
g
g
I
I
I
n
n
n
f
f
f
o
o
o
r
r
r
m
m
m
a
a
a
t
t
t
i
i
i
o
o
o
n
n
n
This function saves the pair setting information for the selected disk array to a file.
On the menu bar, do the following:
• Click [File], and then click [Save the Pair Setting Information].
Figure 3-49 shows an example of the Save Pair Setting Information screen.
Figure 3-49 Example of Save Pair Setting Information Screen
A file that stores pair setting information can be used for “Replication Setting” of “New Setting” which
is one of configuration setting functions. For details, refer to the “Configuration Setting Tool User’s
Manual (GUI)”.
[Pair List]
This section describes the pair list that is output to a file by the replication management function.
* The AT-group information can also be output to a CSV file. For details, refer to the “Data
Replication User’s Manual (Disaster Recovery System Installation and Operation Guide)”.
Pair list format rules
(i) The file is a text file in the ASCII character format. (The default file name is pairlist.txt.)
(ii) Text from a semicolon (;) or sharp (#) to the end of the line is regarded as a comment.
(iii) There is a distinction between upper- and lower-case characters.
(iv) Data is described in the following format.
“MV DiskArrayName”,”MV OSType”,”MV ExVolName”,”RV DiskArrayName”,”RV
OSType”,”RV ExVolName”