Filter
Top Products
Chapter 3 Replication Management
77
[Execution Conditions]
To perform Forced Separate, the following conditions must be satisfied.
(i) The target volume is recognized by Replication Management as the Replication target disk.
(ii) The target MV and RV are paired, or one of them is forcibly separated.
(iii) The disk array where the specified MV and RV are stored is not in the Freeze state.
(iv) The disk array where the specified volume is stored is monitored.
(v) The specified MV or RV is not registered in the AT-group.
Figure 3-37 illustrates the execution conditions of Forced Separate. (Each of (i) to (v) in the figure
corresponds to the respective number above.)
Figure 3-37 Execution Conditions of Forced Separate
Target Pair
MV
RV
(i) Replication Target Disk
(ii) Pair Setting
(iii) Not in the Freeze state
(iv) Disk array monitored
(v) The specified MV or RV is not
registered in the AT-group