Filter
Top Products
Chapter 4 Functions of ReplicationControl
149
On the UNIX system
[Start message]
Separate Start YYYY/MM/DD hh:mm:ss
MV:special_file_name ld_name type
RV:special_file_name ld_name type
[Execution message]
Separating...
[End message]
Separate Normal End YYYY/MM/DD hh:mm:ss
MV:special_file_name ld_name type
RV:special_file_name ld_name type
Description
The execution message and the end message appear only when -wait has been specified to wait for
the Separated state.
If you do not want the execution message to appear, specify the RPL_WAITMSG environment
variable. For information about environment variables, refer to the “Data Replication Command
Reference”.
YYYY/MM/DD hh:mm:ss: Start/End time (Year Month Day Hour Minute Second)
special_file_name: Special file name
ld_name: Logical disk name
type: OS type
Separating...: The “.” character is dynamically updated until Separate is
completed.
[Execution Conditions]
To perform Separate, the following conditions must be satisfied.
(i) The target MV and RV are paired.
(ii) The target MV or RV has been registered in the volume list.
(iii) The volume list is not being created or updated.
(iv) When starting Separate, the file system cache used for MV until the instruction is executed must
be flushed or placed in unmount state to complete updating to MV.
(v) The disk array where the specified MV and RV are stored is not in the Freeze state.
(vi) The Synchronous state of the target pair is not the Restore execution state.
(vii) Specifying a volume of a dynamic disk or a GPT-format partition disk is not allowed (Windows
only).
(viii) The iSM dedicated special file is not being created (HP-UX version UNIX only).