Filter
Top Products
Chapter 4 Functions of ReplicationControl
165
4
4
4
.
.
.
6
6
6
.
.
.
6
6
6
R
R
R
e
e
e
p
p
p
l
l
l
i
i
i
c
c
c
a
a
a
t
t
t
i
i
i
o
o
o
n
n
n
S
S
S
t
t
t
a
a
a
t
t
t
e
e
e
D
D
D
i
i
i
s
s
s
p
p
p
l
l
l
a
a
a
y
y
y
C
C
C
o
o
o
m
m
m
m
m
m
a
a
a
n
n
n
d
d
d
To display the replication state, the iSMrc_query command is used.
As the target volume, MV and RV to be specified must be paired beforehand. In addition, MV and
RV to be specified must be registered in the volume list (created by iSMvollist).
[Main Options]
The iSMrc_query command enables the specification of the following options:
(1) Specifying paired volumes
Specify MV and RV volumes.
y Specify MV (-mv volume -mvflg mv_flg)
Specifies the volume and volume type of MV.
y Specify RV (-rv volume -rvflg rv_flg)
Specifies the volume and volume type of RV.
For information about volume types, refer to 4.3 “Volume Types”.
The target volumes (MV and/or RV) can be specified in any of the combinations below.
y MV and RV
Waits for a specified pair of volumes to enter a target state.
y MV only
Waits for all the pairs set with MV to enter a target state.
y RV only
Same operation as when MV and RV are specified
[Displayed Information]
The iSMrc_query command displays the following information.
On the Windows system
[Displayed information]
MV: Disk No. disk_number
LD Name ld_name
Type type
Volume Name volume_name
Path path
RV: Disk No. disk_number
LD Name ld_name
Type type
Volume Name volume_name
Path path
Activity State activity