Filter
Top Products
11-10 Firmware User Guide
Updating firmware
Firmware updates may be available periodically from Netopia or from a site maintained by your organization’s
network administration.
Follow these steps to update the Router’s firmware:
1. Make sure you have the firmware file on disk and know the path to its location.
2. Select Send Firmware to Netopia and press Return. The following dialog box appears:
3. Select CANCEL to exit without downloading the file, or select CONTINUE to download the file.
If you choose CONTINUE, you will have ten seconds to use your terminal emulation software to initiate an
XMODEM transfer of the firmware file. If you fail to initiate the transfer in that time, the dialog box will
disappear and the terminal emulation software will inform you of the transfer’s failure. You can then try
again.
The system will reset at the end of a successful file transfer to put the new firmware into effect. While the
system resets, the LEDs will blink on and off.
X-Modem File Transfer
Send Firmware to Netopia...
Get Configuration Destination... Current Configuration
Send Config to Netopia...
Send Configuration... Current Configuration
Receive Config from Netopia...
+--------------------------------------------------------------------+
+--------------------------------------------------------------------+
| Are you sure you want to send a firmware file to your Netopia? |
| If so, when you hit Return/Enter on the CONTINUE button, you will |
| have 10 seconds to begin the transfer from your terminal program. |
| |
| CANCEL CONTINUE |
| |
| |
+--------------------------------------------------------------------+