Filter
Top Products
Configuring ISDN and Leased Line Connections 2-5
6. Select Directory Number 1 and enter the primary directory
number as you would dial it, including any required prefixes
(such as area, access, and long-distance dialing codes). Press
Return.
Note: If you select an IDSL (Pt-to-Pt) switch, the Directory
Number 1 field will default to 555-1234.
Since an IDSL line is already physically hooked up in a pt-to-pt
configuration, a specific directory number is not necessary.
However, the Netopia Router does require a directory number in
this field to allow a connection to dial out.
7. If you have a second directory number, select Directory
Number 2 and enter the secondary directory number as you
would dial it, including any required prefixes (such as area,
access, and long-distance dialing codes). Press Return.
8. Select Data Link Encapsulation and highlight the method of
encapsulation that you want to use from the pop-up menu. The
choices offered are PPP or HDLC. Press Return.
In order for the changes that you have entered in the ISDN Line
Configuration screen to take effect, you must reset the Netopia
Router. Press the Escape key to return to the Main Menu. Select
Statistics, Utilities, Tests and then select Restart System.
Leased line WAN Setup
The leased line WAN Setup screen will vary for an SA/Serial, 56k
DDS, or T1 line depending on the circuit type and datalink
encapsulation parameter that is selected for that specific leased
line.
To begin WAN Setup, select WAN Setup in the Advanced
Configuration menu, then press Return.
Main
Menu
Advanced
Configuration
WAN
Setup
• Line Configuration
• Frame Relay Configuration
• Frame Relay DLCI Configuration
• Connection Profiles
• Default Profile