Filter
Top Products
IP Setup 4-13
Next Gateway: The IP address of the router that will be used to
reach the destination network.
Priority: An indication whether the Netopia Router will use the static
route when it conflicts with information received from RIP packets.
Enabled: An indication whether the static route should be installed
in the IP routing table.
Adding a static route
To add a new static route, select Add Static Route in the Static
Routes screen and go to the Add Static Route screen.
Add Static Route
Static Route Enabled: Yes
Destination Network IP Address: 0.0.0.0
Destination Network Subnet Mask: 0.0.0.0
Next Gateway IP Address: 0.0.0.0
Route Priority... High
Advertise Route Via RIP: No
ADD STATIC ROUTE NOW CANCEL
Configure a new Static Route in this Screen.
■ To install the static route in the IP routing table, select Static
Route Enabled and toggle it to Yes. To remove the static route
from the IP routing table, select Static Route Enabled and
toggle it to No.
■ Be sure to read the rules on the installation of static routes in
the IP routing table. See “Rules of static route installation” on
page 4-15.
■ Select Destination Network IP Address and enter the network
IP address of the destination network.