IV - 62
Section IV - TCP/IP
OKI OkiLAN 6010e User’s Guide
Unable to Assign IP Address
Gleaning
If you ping the device and are not getting a response,
the glean is not working. Check the following possible
problems:
• Verify the ARP table contains the correct
hardware and IP address by running the
‘arp –a’ command.
• If you are getting a response, but the
OkiLAN 6010e LED is still blinking green,
power down the print server and try the ping
again. There might be a different device
answering to the ping.
• Verify the OkiLAN 6010e is on the same
subnet as the computer running the ping.
• The glean will not work if the OkiLAN
6010e has already defaulted to an IP address
two minutes after power up. The LED will
turn solid green and the device will print a
configuration page. Power cycle the device
and try the glean again.