Filter
Top Products
TCP/IP
IV - 65
Section IV - TCP/IP
OKI OkiLAN 6010e User’s Guide
• Verify the OkiLAN 6010e is on the same
subnet as the host from which you are
telneting. As a drastic measure, try creating
an isolated subnet with your host and the
OkiLAN 6010e. If you are using 10BASE2,
run the cable directly from the host to the
OkiLAN 6010e. If using 10BASE-T cabling,
connect the host to the OkiLAN 6010e
through a hub not connected to any other
host.
• If the static route has been set up and can
telnet to the OkiLAN 6010e, but your
changes do not seem to be saved, check the
host’s routing tables. You might have
telneted to a different OkiLAN 6010e than
the one you intended. While in telnet, select
the second menu option, Show Network/
Printer Information. The hardware address
and serial number are displayed. Verify they
are the same as the unit you are configuring.
• Turn off the OkiLAN 6010e you want to
configure. Run telnet again. If you reach a
different device, there is an IP address
conflict.
• If you are able to ping to the OkiLAN
6010e, but are unable to telnet, the IP ad-
dress is probably being shared with another
device that does not support telnet.