Oki 6010E Printer User Manual


 
Hardware Installation
I - 11
Section I - Hardware Installation
OKI OkiLAN 6010e User’s Guide
Solution
a) Unplug the OkiLAN 6010e power adapter from the
wall outlet. Remove the network cable. Plug the
network cable back in until you hear a positive
click. Check the other end of the cable in the same
manner. Plug the OkiLAN 6010e back in. If it does
not detect a cable, continue below.
b) Verify the cable is a 10Base-T cable and it has an
RJ-45 end. The network cable must have a cat-3 or
higher rating. Silver Satin or flat ribbon cable is
not adequate.
c) Connect to a network that a currently working PC or
print server is using. If the OkiLAN 6010e is still
unable to detect the network cable, contact Techni-
cal Support for assistance.
LED Display
LED is flashing green slowly (1 timer/sec);
the OkiLAN 6010e is trying to print a job.
Problem
The printer is malfunctioning or does not have sufficient
paper or toner.
Solution
Verify that the printer is not showing any errors and has
sufficient paper and toner.
LED Display
LED is solid orange for more than 30 seconds
Problem
The printer server has failed the Power On Self Test.
Solution
The OkiLAN 6010e will try to print a configuration
sheet on the printer with more information.