TCP/IP
IV - 7
Section IV - TCP/IP
OKI OkiLAN 6010e User’s Guide
Network Preparation
• You should be familiar with network admin-
istration as well as the physical setup and
operation of your network.
• Advise users of possible disruption during
installation.
• Make sure the serial number and Ethernet
address of your OkiLAN 6010e are avail-
able.
• Assign an IP address and a hostname (alias)
to the OkiLAN 6010e.
• Use the network name service or the “/etc/
hosts” file to add the OkiLAN 6010e to the
network.
Before You Start
Before running OkiNet for TCP/IP, you must do the
following:
• Install the OkiLAN 6010e hardware and
connect the cabling. Instructions for hard-
ware installation are found in Section I of
this manual.
• Write down the serial number and Ethernet
address of your OkiLAN 6010e. (These
numbers are located on the OkiLAN 6010e
board.)
• Install OkiNet for TCP/IP—see Section I.