Filter
Top Products
Page: 67
Service Manual for OF5800
Chapter 3 Adjustment Procedures
Bit
Initial Setting Adjustment Usage / Comments
7 0 Program individual
autodialer attributes.
0: No
1: Yes
Allows individual setting of memory switches
B:0 as attribute 1, B:1 as attribute 2 and B:2 as
attribute 3 and B:3 as attribute 4 when
one-touch and speed dial locations are
programmed.
6 0 Relay broadcast
0: No
1: Yes
5 0 Proprietary handshake
0: No
1: Yes
Enable the OKIFAX 5800 proprietary
handshaking protocol.
4 0 Factory use only
3 0 Factory use only
2 0 Sending RTC signal
when transmission is
canceled
0: Yes
1: No
1 1 Cancel redial if T.4.1 or
T4.4 error occurs.
0: Yes
1: No
RTC signal is sent at the end of the
transmission. when set at "0", the unit will send
the RTC if the tx is canceled. No error will
occur. When set at "1", an error will occur
because RTC will not be sent at the end of a
canceled transmission.
1 1 Cancel redial if T.4.1 or
T.4.4 error occurs.
0: Yes
1: No
When set at "0" if a T.4.1 or a T.4.4 error
occurs, the unit will not retry the transmission
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)