Filter
Top Products
CLEARING PAPER JAMS > 196
>
To remove a sheet from the central area of the belt (2),
carefully separate the sheet from the belt surface and
withdraw the sheet.
>
To remove a sheet just entering the fuser (3), separate
the trailing edge of the sheet from the belt, push the
fuser pressure release lever (4) towards the front and
down to release the fuser’s grip on the sheet, and
withdraw the sheet through the drum cavity area. Then
allow the pressure release lever to rise again.
NOTE
If the sheet is well advanced into the fuser (only a short length is still
visible), do not attempt to pull it back. Follow the next step to remove it
from the rear of the printer.
4
2
3
1