Filter
Top Products
22
Specifications and Configurations Section 1-2
2. For automatic data link creation with 1:N allocations or when changing
data link tables while the data link is active (CS1W-CLK21-V1 and CJ1W-
CLK21-V1), use the CX-Net in CX-Programmer version 3.2 or higher.
Controller Link Support Software (Version 2.00)
The Controller Link Support Software can be used to manually set data links,
to set Controller Link parameters, and to monitor the Controller Link Network.
The Controller Link Support Software is run on a personal computer con-
nected to a C200HX/HG/HE, CVM1, or CV-series PLC or a personal com-
puter in which a Controller Link Support Board has been mounted.
• Setting the data link mode to “manual” (creating and storing data link
tables).
• Starting/stopping data links.
• Reading (monitoring) network status.
• Reading error logs.
• Setting routing tables.
• Testing the Network.
• Changing network parameters.
• Reading the network connection configuration data and status (in token-
ring mode only).
Using an Independent
Computer
A computer that is not part of the Network can be used to control the Control-
ler Link Network.
Note 1. The Controller Link Support Software cannot be connected to a CS/CJ-se-
ries PLC. It is possible to monitor and set a Controller Link Unit on a CS/
CJ-series via the network by connecting the computer running the Control-
ler Link Support Software to a C200HX/HG/HE, CVM1, CV-series, or
CQM1H-series PLC.
2. The Controller Link Support Software can be used as a part of the SYS-
MAC Support Software.
Nodes
Controller
Link Unit
CPU Unit
+
C200HX/HG/HE and
CQM1H-series PLCs
Nodes
Controller
Link Unit
CPU Unit
CVM1 and CV-series PLCs
Transmissions
Setting data link tables
Controller Link
Support Software
RS-232C
IBM PC/AT or
compatible
Nodes
Controller
Link Unit
CPU Unit
CS-series PLCs
RS-232C
C200HX/HG/HE,
CVM1, and CV-series
PLCs
CS-series PLC
…