Filter
Top Products
6-5SectionOperations in the System Installer Mode
151
6-5-1 Setting the Display Language in the System Installer Mode
The first setting made in the System Installer mode is to select whether the dis-
play language is to be English or Japanese.
Select English or Japanese.
From here on, this manual assumes that
English has been selected here.
The System Installer mode menu is dis-
played.
If there is no system program or the system
program has been corrupted, the message
System Program not exist or incorrect. is
displayed at the bottom of the screen.
6-5-2 Clearing/Installing the System Program
Use this function when the system program of the NT31/NT31C has been cor-
rupted, or when installing a new system program.
Reference: S In order to install a system program, the system installer must also be installed
at the Support Tool. The system installer is an accessory with the Support Tool
(NT-ZJCAT1-EV4). When installing the Support Tool in a personal computer,
install the system installer also. For details on the method for installing the sys-
tem installer at the Support Tool side, and the operating procedure, refer to the
NT-series Support Tool Ver. 4.1 for Windows Operation Manual (V061-E1-j).
S When the system program is cleared by mistake, it becomes impossible to use
the NT31/NT31C at all. Check that the system installer is installed at the Sup-
port Tool side before deleting the program. However, note that the registered
screen data and memory switch settings are retained.
S It becomes possible to install the system program inside the memory unit auto-
matically by installing the memory unit at startup. (Refer to 3-5 Using a Memory
Unit (-Vj Versions).)
Clear/install the system program by following the menu operation from the Sys-
tem Installer mode menu shown below.