Omron NT31 NT31C Network Card User Manual


 
6-9SectionSystem Settings
169
The four memory switch setting screens are shown below.
[ ] (next screen)
[ ] (next screen) [ ] (previous screen)
[ ] (previous screen)
[ ] (next screen) [ ] (previous screen)
[ ] (next screen)
[ ] (previous screen)
Memory Switch Settings
A list of the memory switch settings is presented below.
Start-up Wait Time page 169
Key Press Sound page 170
Buzzer Sound page 171
Printer Controller page 172
Print Method page 174
Screen Saver Movement page 175
Screen Saver Start up Time page 177
Hist. Disp. Method page 179
Resume Function page 181
Comm. Auto-return page 183
Time-out Interval page 185
Retry Counts page 186
Comm. A Method page 157
(For the bar code reader, refer to page 188.)
Comm. B Select page 167
Comm. B Method page 157
For details on each setting, refer to the pages indicated.
6-9-2 Setting the Start-up Wait Time
The Start-up Wait Time is the time lapse until the NT31/NT31C switches to the
RUN mode after its power has been switched ON or after it has been reset. Set
this item if it takes some time for the host to start operation. Nothing is displayed
during the Start-up Wait Time.
The setting range is 0 to 10 seconds. The default (factory) setting is 00sec.