Filter
Top Products
29
-
iRIS 220 / iRIS 320, V1.19 User Guide
4.3.5 Phone List (Level 3)
The Phone List menu is the place to configure your primary and secondary phone numbers for SMS text
messaging or CSD dial-up initiated by the iRIS. These numbers are only applicable when the Callback mode
is set to 1 (SMS) or 2 (CSD). See the description of the callback mode, option 6 in Section 4.3.3.
* Phone List
0 Exit
1 Pri Phone No [+6478570810]
2 Sec Phone No [+6478570811]
>
Option 0
Select this option to return to the Comms Cfg menu.
Option 1
When this option is selected you will be prompted to enter the primary SMS or CSD phone number.
> Pri Phone No=
Enter the number of the main cellphone that will receive iRIS initiated text messages (SMS mode) or a
primary telephone number of the base station that the iRIS should call when initiating dial-up
communications (CSD mode). In the case of landline numbers, as the call is being made over a cellular
network, the full STD prefix must be included even if the call is “local”.
Option 2
When this option is selected you will be prompted to enter the secondary SMS or CSD phone number.
> Sec Phone No=
Enter the number of a second cellphone that will also receive iRIS initiated text messages (SMS mode) or a
secondary telephone number of the base station that the iRIS should call when initiating dial-up
communications (CSD mode). In the case of landline numbers, because the call is being made over a
cellular network, the full STD prefix must be included even if the call is “local”.
4.3.6 IP Acceptance Cfg (Level 4)
The IP acceptance set-up menu is the place to configure your IP address acceptance list.
NOTE: The iRIS will always respond to messages from the IP addresses programmed for socket A
and socket B since these are the defaults used for unsolicited calls. If your unit is connected to the
iQuest APN and you would like iQuest to have access to the device for maintenance and support
purposes, enter the iQuest Host IP Address (192.168.1.10) into one of the table entries – the default
place for this address is entry 5. See Appendix F for a listing of the iQuest network settings.
* IP Acceptance Cfg
0 Exit
1 IP #1 [0.0.0.0]
2 IP #2 [0.0.0.0]
3 IP #3 [0.0.0.0]
4 IP #4 [0.0.0.0]
5 IP #5 [0.0.0.0]
>
Option 0
Select this option to return to the GPRS/CDMA-1X set-up menu.
Options 1 - 5
Select any of these options to enter the IP address of host #1 – host #5 respectively.