Filter
Top Products
Setting the system event log 33
Table 6 "logging command parameters and variables" (page 33) describes
the parameters and variables for the logging command.
Table 6
logging command parameters and variables
Parameters and variables Description
enable | disable
Enables or disables the event log
(default is enabled).
level critical | serious |
informational
Specifies the level of logging stored
in DRAM.
nv-level
critical | serious |
informational | none
Specifies the level of logging stored in
non-volatile memory (NVRAM).
no logging
The no logging command disables the system event log on the Ethernet
Switch 470-24T. The syntax for the no logging command is:
no logging
The no logging command is in the config command mode.
The no logging command has no parameters or variables.
set logging
The set logging command configures the system settings of the system
event log for the Ethernet Switch 470-48T or the Ethernet Switch 460-24T.
The syntax for the set logging command is:
set logging [enable | disable] [level
critical | serious | informational] [nv-level
critical | serious | informational | none]
The set logging command is in the config command mode.
Table 7 "set logging command parameters and variables" (page 33)
describes the parameters and variables for the set logging command.
Table 7
set logging command parameters and variables
Parameters and variables Description
enable | disable
Enables or disables the event log
(default is enabled).
Nortel Ethernet Switch 460/470
Configuration — System Monitoring
NN47210-503 01.01 Standard
3.7 22 February 2007
Copyright © 2005-2007, Nortel Networks Nortel Networks Confidential
.