Filter
Top Products
Using port mirroring 39
default logging remote level command
The default logging remote level command sets the severity level
of the logs you send to the remote server to the default value, which is None.
The syntax for the default logging remote level command is:
default logging remote level
The default logging remote level command is in the config
command mode.
The default logging remote level command has no parameters
or variables.
Using port mirroring
Note: For guidelines to port mirroring, refer to "Port mirroring" (page 17).
You use port mirroring to monitor traffic. This section covers the following
commands:
•
"show port-mirroring command" (page 39)
•
"port-mirroring command" (page 40)
• "no port-mirroring command" (page 41)
show port-mirroring command
The show port-mirroring command displays the port mirroring
configuration. The syntax for the show port-mirroring command is:
show port-mirroring
The show port-mirroring command is in the privExec command mode.
The show port-mirroring command has no parameters or variables.
Figure 10 "show port-mirroring command output" (page 39) displays sample
output from the show port-mirroring command.
Figure 10
show port-mirroring command output
Nortel Ethernet Switch 460/470
Configuration — System Monitoring
NN47210-503 01.01 Standard
3.7 22 February 2007
Copyright © 2005-2007, Nortel Networks Nortel Networks Confidential
.