Filter
Top Products
3URGXFW5HIHUHQFH*XLGH 6-37
6FDOH$XWRPDWLF=HURLQJ
This feature enables/disables automatic zeroing of the scale if it goes under
zero. If an under-zero condition is detected and persists for at least five
seconds, the scale will be zeroed as it the zero button had been pressed.
This feature ensures accurate weighing by automatically zeroing after
under-zero conditions are detected, such as after the platter has been
cleared.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan your selection from the two bar codes below. You’ll need to
cover any unused bar codes on this and the facing page to ensure
that the scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
SCALE AUTOMATIC ZEROING = DISABLE
SCALE AUTOMATIC ZEROING = ENABLE