Filter
Top Products
Reception Features
102
5
❖
❖❖
❖ Priority Table
• KK and LL indicate that the
message is split over two pages of
paper with the orientation and size
shown.
Note
❒ Paper placed in the bypass tray is
not usually selected for printing a
received message. However, you
can use this tray if you select the
bypass tray as the main paper tray
using Reception with Specified
Senders. See p.171 “Special Send-
ers to Treat Differently”.
❒ Widths that this machine can re-
ceive are A4, B4 JIS, and A3. Any
messages narrower than A4 are
sent as A4 width with the length
unchanged.
❒ The paper size used to print a re-
ceived message may be different
from the size of the sent original.
❒ If you specify a receiving tray with
the setting priority under System
Settings, the messages may be re-
ceived in a different order by set-
ting the priority table. The priority
tray may be used only when the
document received is the same size
as the priority tray.
Reference
p.99 “Image Rotation”
p.100 “Page Separation and
Length Reduction”
p.101 “Page Reduction”
“Tray Paper Settings”, General Set-
tings Guide
Setting priority trays
With the same size of paper loaded
into multiple trays, you can make the
machine use one tray for one function
and another tray for another function.
For example, you may load white A4
paper into tray 1 to use when making
copies, and yellow A4 paper into tray
2 to use when printing received faxes.
You can then easily identify for which
purpose paper has been output. You
can perform this setting using System
Settings. See “Tray Paper Settings”,
General Settings Guide.
Note
❒ When a different size of document
from the priority tray is received,
the tray containing the same size of
paper as the received document is
used.
Page reduction Disabled
Reduction in Sub-
scan Direction
Enabled
Page Separation
Threshold
20mm (0.79")
Width or Length Pri-
ority
Width
JupterC2_Fax_EN-F_FM.book Page 102 Monday, November 29, 2004 3:48 PM