Filter
Top Products
Administrator Setting
176
9
C Press the destination key of a
forward destination, and then
press [OK].
Limitation
❒ One forward destination can
be registered for a destina-
tion. To register two or more
forward destinations, use
Group Destinations. Howev-
er a maximum of 500 parties
can be specified in a group.
Note
❒ Press the button on the right
of the display to switch the
destination between fax
number, e-mail address, IP-
Fax destination, and folder.
❒ Set folder destinations using
the Address Book Manage-
ment function under System
Settings. See “Registering
Folders”, General Settings
Guide.
❒ When a folder is specified as
the forward destination, you
can set a file format for for-
warding. See p.166 “User Pa-
rameters” (switch 21, bit 3).
❒
Deleting a destination speci-
fied as a forward destination
from the destination table
causes the settings of the for-
ward destination to be delet-
ed, so they must be registered
again.
When a destination is
changed, a message is trans-
mitted to the new destina-
tion. If there is no destination
of the specified type, you can
set a certain destination to be
priority quoted. See p.166
“User Parameters” (switch
32, bit 0).
D Press [OK].
E Press [OK].
Note
❒ After you perform step
K
, set
“Forwarding” of “Reception
Settings” to “On”. See p.147
“Reception Settings”.
Reception File Print Qty
A Select [Reception File Print Qty].
B Press [Number of Sets].
Note
❒ Selecting [
Same as Basic Set-
tings
] will result in the same
setting made for “RX File
Print Qty” of “Reception Set-
tings”. See p.147 “Reception
Settings”.
JupterC2_Fax_EN-F_FM.book Page 176 Monday, November 29, 2004 3:48 PM