Filter
Top Products
Polling Transmission
13
1
E
EE
E
Press [Only Once] or [Save] to delete
or save the file after transmission.
Note
❒ To delete the original immedi-
ately after transmission, select
[Only Once].
❒ To repeatedly send the original,
select [
Save
].
❒ To cancel Polling Transmission,
press [
Cancel
]. The display re-
turns to that of step
C
.
F
FF
F
Press [
OK
].
“pppppppppp” ap-
pears.
The type of Polling Transmission is
shown above the highlighted [
Poll-
ing TX
].
G
GG
G
Press [OK].
Note
❒ To check the settings, press
[Transmission Mode].
H
HH
H
Press the {
{{
{Start}
}}
} key.
Note
❒ You can cancel the transmission
setup for Polling Transmission.
See p.19 “Canceling a Transmis-
sion”.
Polling Transmission Clear
Report
This report allows you to verify Poll-
ing Transmission has taken place.
If E-mail TX Results is programmed
in a Quick Operation key, you can
have the report e-mail sent after
transmission. See p.146 “Quick Oper-
ation Key”.
Limitation
❒ This report is not printed if the
User Parameters are set to allow
the stored originals to be repeated-
ly sent (Save). See p.166 “User Pa-
rameters” (switch 11, bit 7).
Note
❒ You can turn this function on or off
with the User Parameters. See
p.166 “User Parameters” (switch
03, bit 6).
❒ You can have a portion of the sent
image printed on the report with
the User Parameters. See p.166
“User Parameters” (switch 04, bit
7).
❒ You can check the result of Polling
Transmission with the Journal. See
p.27 “Printing the Journal”
❒ To view the report without text
disruption, select a font of even
character width in your e-mail ap-
plication's settings.
❒ You can display a destination with
the User Parameters. See p.166
“User Parameters” (switch 04, bit
4).
❒ You can indicate the receiving par-
ty's information with the User Pa-
rameters. See p.166 “User
Parameters” (switch 04, bit 5).
JupterC2_Fax_EN-F_FM.book Page 13 Monday, November 29, 2004 3:48 PM