Filter
Top Products
Printing Options
103
5
Just size printing
If you enable this function, received
documents are printed on the sheet
that has highest priority. See p.102
“Priority Table”. This function is en-
abled with User Parameters. See
p.166 “User Parameters” (switch 05,
bit 5).
If the paper tray is not stocked with
paper of a suitable size to print a re-
ceived document, a message appears
on the display prompting you to load
paper of the required size. When you
have loaded new paper, press [
Exit
] to
print the document.
Note
❒ After pressing [Exit], procedure
varies depending on machine sta-
tus when the message occurred.
•
If any received documents or re-
ports were being printed automat-
ically, the printer automatically
continues printing from where it
left off.
• If any documents or reports
were being printed manually,
the printer does not resume
printing. Perform the operation
from the beginning again.
Having Incoming Messages Printed on
Paper from the Bypass Tray
You can print messages sent from
Specified Senders on paper from the
bypass tray.
Set as follows:
• Program a special sender and se-
lect the Bypass Tray for the paper
tray type. See p.178 “Programming
Bypass Tray Paper Size” under
“Program Special Sender”.
• Turn on the Authorized RX func-
tion under the Program Special
Sender function. See p.178 “Pro-
gramming Authorized RX and
Special RX Function”.
Limitation
❒ When using this function, printed
sheets cannot be delivered to the
finisher output tray. Even if you
specify the finisher output tray,
sheets are delivered to the Internal
Tray 1. See “Tray Paper Set-
tings:Fax”, General Settings Guide.
Note
❒ You can load a maximum of 100
sheets of standard paper in the by-
pass tray.
❒ You can use a size of paper not
stocked in the paper tray(s) in the
bypass tray.
❒
The machine can detect A5
L
, A4
L
,
A3L, 5
1
/
2
"×8
1
/
2
"L, 8
1
/
2
"×11"L,
11"×13"L, 8"×13"L paper sizes.
When you load any other size,
specify the paper size. However, if
the specified paper size and size of
paper set in the bypass tray do not
match, paper jams may occur, or
the image may be shortened. See
p.178 “Programming Bypass Tray
Paper Size”.
JupterC2_Fax_EN-F_FM.book Page 103 Monday, November 29, 2004 3:48 PM